1. General
  2. Ideas
0
Under review

Where is the charger fuse located?

DanDiego 8 years ago • updated 8 years ago • 5

Bike doesn't charge. I see a charger replacement fuse kit on the website. Where exactly is the fuse located? Did not see it in the manuals. Thanks.

Answer

Answer
Under review
piotrstec (Managing Director) 8 years ago

DanDiego

Our charger fuse kit is an upgrade - DIY instalation kit. Oryginally chargers where not equipped in fuse.

Armand is right - sometimes disconnecting the charger will reset it - you need to disconnect the DC cable. It's location deppends on the type of charger you have.

Check the links below: Charger Types - compatibility with Lithium Batteries SX-BC-CONV

Battery Charger Replacement S-XC-S00540


Do be sure that charger doesn't work you need to check what is the battery voltage. Below 80V it won't start by itself.


For the turnsignal LED bulb - http://shop.vectrixparts.com/lp-illuminator-assembly-724.html


Regards

armand cappello 8 years ago

Hello DanDiego, have you try to reset the charger, for this just unplug the center connection on it and plug again after few seconds

DanDiego 8 years ago

Where is the center connection? I have a service manual and am starting to take the bike apart. Also, do you have replacement parts for the front turn signal LEDs? Thanks!

Answer
Under review
piotrstec (Managing Director) 8 years ago

DanDiego

Our charger fuse kit is an upgrade - DIY instalation kit. Oryginally chargers where not equipped in fuse.

Armand is right - sometimes disconnecting the charger will reset it - you need to disconnect the DC cable. It's location deppends on the type of charger you have.

Check the links below: Charger Types - compatibility with Lithium Batteries SX-BC-CONV

Battery Charger Replacement S-XC-S00540


Do be sure that charger doesn't work you need to check what is the battery voltage. Below 80V it won't start by itself.


For the turnsignal LED bulb - http://shop.vectrixparts.com/lp-illuminator-assembly-724.html


Regards

piotrstec (Managing Director) 8 years ago

Now I see the beginning of conversation.

What happens if you turn the ignition ON. Is the display alive?

If not - check the battery voltage by multimeter.

DanDiego 8 years ago

Right now the charger is out of the bike. When I turn on the key, the instruments light up and I see almost half of the bars are left. The bike was running last time I checked, before I removed the charger. I will put it up on the center stand and see if the rear wheel spins.

Customer support service by UserEcho