Charger - Data Signal Harness replacement - SX-000209


  1. Remove both side front fairings - refer to S-XC-S10900
  2. Remove NiMH battery - refer to NiMH S-ST-100000
  3. Remove battery charger - refer to S-XC-S00540
  4. Cut zip-ties holding Charger Data harness and connector (1)

    Image 419
  5. Disconnect VEC5000 connector

    Image 420
  6. Remove VEC5000 harness by pulling it out as shown in the picture below

    Image 421

This article was helpful for 1 person. Is this article helpful for you?