Hello, I would like to buy new bms board, my batteries system is composed with 36 cells, how many board I have to buy? 3 (with your description, 1 board can read 12 cells) or 4 to be compatible with can bus or other ? The connector j24 and j25 are welded on the board or I have to buy too? And how the software is integrated in the board ? Thanks Clement 

Hello Piotr 

Thanks for your feedback, but I have bought a pic debugger and I succeed to debug the ICM board. 

Thanks

Clement 

hello piotr or Mateo 

I have 2 questions :

- I cannot communicated with the ICM board (red in the diagnostic soft), it’s possible to send you the ICM board and reprogramming the PIC ? 

- I want convert the vx1 with 52Ah, but it’s possible to configure the charger with this power ? How I can configure the soft?

Thanks for your feedback

Clément 

Hello Mateo

Thanks for your feedback, In attachment, I have drown a battery modification, you are ok with this schematic ? Thanks clement

hello piotr

I have a vectrix vx1 li+ but my battery are died.

So I would like to transform my lifepo4 by cells panasonic NCR18650B.

My charger is a gold with serial V21, I have 4 BMS board with 10 connections Each for 10 cells.

Can I reused these BMS board with only 8 cells (36s and not 40s before with the lifepo4) and use your box adaptator following http://shop.vectrixparts.com/vx1-bms-adaptor-pcb-case.html

Thanks a lot for your help

Clement