thank you very much 

in addition to setting the maximum voltage and power of the charger, is there a way to set the amperes of battery capacity? if so how?

Thanks for your help

is there a guide that lists all the parameters and commands that can be set on the scooter from the scooter?

I only know the one to set the power of the charger and the maximum voltage of the cells. there are others ?

i solved i changed the charger firmware from EVPS LiMn 36s-2.hex to "evpsli02last.hex  and now everything works

I'll try tonight

yes in the Diag software i see all 

Fran 

I found these videos to enter the values the problem is that on my scooter when I scroll the parameters with the rear brake and press 3 times as in the video the cell parameter does not appear but the menu returns to delaythe firmware installedEVPS LiMn 36s-2.hex ICM is DIY_1708.hexMC_FRA20B01.hexwhen it loads in the small lcd display hi and low always mark 0Vectrix VX1, configuración del nivel de carga de la batería.

Greetings to all, new episode, I had the MC board repaired and finally I mounted the battery and the bms loaded the firmware you indicated, I plug it in and finally I see the battery that charges after about 3 hours of charging, keeping d 'eye the cell voltages on the Diagnostic I see that some cells indicate 4.385 volts 3 -4 cells exceed the charging voltage indicated by the house (samsung) which is 4.2 volts Max, I wanted to ask if there is a way to correct this problem, or make the charger push less, are there any possible settings on the diagnostic or other?

G

ood morning everyone I update you on my troubles ... for reasons that I am not explaining the positive on the mc board and went to touch the frame and the scooter does not turn on anymore, I no longer have 12 volts on the j22 connector I replaced the dc dc but nothing has changed, I tried with the tester the current arrives at the input of the dc dc but not at the output (12 volts tested on the bench before mounting it works fine) reading on the forum I found the possibility to turn on the instrument panel by bridging the pins 1- 2 but this too had no effect, I noticed that right next to it there is R1 that seems burned, I have continuity from pin 1 to R1 but absolutely nothing after R1, it seems to me that it is part of the cirquito that gives the ignition to the dcdc but I'm not an electronic so I ask you for advice on what I can do, a big thank you to the whole community