Hi all, I would like to know if I need to connect  cables to the battery and to the rear battery sensor as in the image below and according the following schema:

Thanks, according to your suggestions on https://vectrixparts.userecho.com/en/communities/1/topics/3340-vx-1-not-turning-on-at-all I would replace ignition switch, but if there is a fast way to check ignition switch I could check. I'm interested in Italian Vectrix community on WhatsApp, could I receive more info?

/Tommaso

Thanks, found them. I'm trying to install a new ignition switch, hoping to solve my issue.

Do you know someone in Italy that could resolve my problems? thanks 

Where are the screws of point 3? I don't find them

Hi all, sorry to bother you again, I shorted pin 1-2 and dashboard is on. what should I do now? ignition key has no effect on dashboard, Horn switch does not work, lights are off, i can only change time and km/miles on display nothing else. I think charger is not working but I have some doubts because vx1 is not completely assembled. please kindly check the following picture:

As in the picture?

shorting two pins, connecting the batteries I should have dashboard working?

Hi Azzuro, yes, battery voltage on the screw contact terminals is 125V and I checked also battery voltage on 

J1P Motor Controller Power from black to red I measured 120V.  where can I find 2 adiacent pins on the PS connector?

Hi all, I repaired my vectrix VX-1 by changing both rear and front temperature sensors and repairing some battery cells. after connecting battery pack dashboard is completely off. I bought vectrix not working so I don't know how can I solve the issue.

is there some check I should do?

Thanks

hello Carlos, thanks, I will try programming the same firmware on the boards. You can send it to my address: tommaso.delgrosso@gmail.com

thanks